Change a value of a Zwave device
Publié : 05 oct. 2017, 17:08
Hi,
I have an issue, from time to time, my Fibaro Motion Sensor is kept in "Motion Detected" mode for several hours, and of course there is no motion.
Is there any way, using API or a command, to change the sensor status?
Thanks in advance
I have an issue, from time to time, my Fibaro Motion Sensor is kept in "Motion Detected" mode for several hours, and of course there is no motion.
Is there any way, using API or a command, to change the sensor status?
Thanks in advance